Dam & Safety ›› 2020, Vol. 0 ›› Issue (6): 39-44.

Previous Articles     Next Articles

Dynamic analysis of hydraulic gate driven by bottom shaft

HU Taoyong, HAN Jin and SUN Meiling   

  1. PowerChina Huadong Engineering Co., Ltd.
  • Received:2019-03-27 Revised:2020-06-23 Online:2020-12-08 Published:2020-12-08

底轴驱动闸门动力学分析

胡涛勇,韩  晶,孙美玲   

  1. 中国电建集团华东勘测设计研究院有限公司,浙江 杭州,311122
  • 作者简介:胡涛勇(1977— ),男,江西上饶人,教授级高级工程师,研究方向为金属结构。

Abstract: Based on the gate of Beizhijiang project which is driven by bottom shaft, fluid-structure coupling analysis method is used to analyze the force statement and the force applying on the gate by dynamic water flow with different angles when the gate is opened. Studies have shown that the shear stress and the Mises stress of the gate reach the largest when the gate opening angles are 70° and 75°, which are the worst working conditions for the gate. It is recommended to minimize the dwell time of the gate at opening angles of 70° and 75° during actual operation.

Key words: gate driven by bottom shaft, dynamic analysis, fluid-structure coupling, severe working conditions

摘要: 以北支江水闸项目底轴驱动闸门为依托,针对底轴驱动闸门开闸时不同角度下泄水对闸门产生动水压作用带来的影响进行分析研究,采用流固耦合的方法分析其在动态水流作用下的受力状态。研究表明,闸门转角为70°和75°时,受到的切应力和米塞斯应力最大,此时是最恶劣的工况,建议在实际运行过程中尽量减少在转角70°和75°时的停留时间。

关键词: 底轴驱动闸门, 动态分析, 流固耦合, 恶劣工况